| 1 |
|
3/6/2020 |
Pamela Cole |
Approved |
Redlined -
Sec. 800.055. - Solid waste service areas.
(e)Solid waste service area enclosure standards. When enclosures are used for required screening or aesthetics, such enclosures shall conform to the following standards:
(2) Measures to prevent damage to enclosure.
(B)Enclosures constructed of concrete, brick, masonry block, or similar types of material shall contain a minimum four-inch nominal high bumper curb at ground level located 12 inches inside the perimeter of the outside walls of the enclosure, or a fixed bumper rail to prevent damage from receptacle impacts.
(C)The requirements under subsections (e)(2)(A) and (B) of this section shall not apply if the enclosure is designed to be separated:(i)A minimum distance of two feet from the sides of the container or receptacles; and(ii)A minimum of three feet from the rear of the container or receptacles. |